THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
FAX (630) 851-5040.
PHONE (630) 851-4722.
HTTP://WWW.CONWIN.COM
P R O D U C T D A T A S H E E T
Specifications subject to change without notice.
DATA SHEET #:
REV:
DATE:
PAGE
OF
Copyright 2001 Connor-Winfield all rights reserved.
a
CRYSTAL CONTROLLED OSCILLATORS
The Connor-Winfield
VSLD52C1 is a surface
mount 3.3V Voltage
Controlled Crystal Oscillator
(VCXO) with an HCMOS
output. Based on a
fundamental crystal design
the VSLD52C1 is designed
for phased lock loop
applications requiring low
jitter and tight stability.
1
2
VSLD52C1 - 125.00MHz
VCXO
SERIES
CENTER
FREQUENCY
FEATURES
DESCRIPTION
ORDERING INFORMATION
3.3V OPERATION
TOTAL FREQUENCY TOLERANCE:
50ppm
INDUSTRIAL TEMPERATURE RANGE:
0 to 70C
LOW JITTER <1pS RMS
SURFACE MOUNT PACKAGE
TAPE AND REEL PACKAGING
SURFACE MOUNT 3.3V HCMOS VCXO
VSLD52C1
Vx521
00
9/14/04
CW 0434
VSLD52C1
125.00M
Notes
1.0
Inclusive of calibration, frequency vs. temperature s tability, supply voltage change, load change, shock and vibration and
aging over 15 years, Vc=1.65 Vdc.
2.0
Referenced to Fo @ 25C. Positive Slope.
3.0
Absolute pull range (APR) is the minimum guaranteed pull range of the VCXO under all conditions over lifetime operation.
The APR is referenced to Fo.
ABSOLUTE MAXIMUM RATINGS
TABLE 1.0
PARAMETER
UNITS
MINIMUM
NOMINAL MAXIMUM
UNITS
NOTE
Storage Temperature
-40
-
85
C
Supply Voltage
(Vcc)
-0.5
-
7.0
Vdc
Control Voltage
(Vc)
-0.5
-
7.0
Vdc
OPERATING SPECIFICATIONS
TABLE 2.0
PARAME TER
MINIMUM NOMINAL MAXIMUM
UNITS
NOTE
Center Frequency
(Fo)
2
-
156.25
MHz
Frequency Stability (Vc=1.65V)
-45
-
45
ppm
Aging (15 years)
-5
-
5
Total Frequency Tolerance
-50
50
ppm
1
Operating Temperature Range
0
-
70
C
Supply Voltage
(Vcc)
3.135
3.300
3.465
Vdc
Supply Current
(Icc)
-
-
50
mA
Jitter (BW=10Hz to 20MHz)
-
-
5
pS rms
Jitter (BW=12kHz to 20MHz)
-
-
1
pS rms
SSB Phase Noise at 10Hz offset
-
-65
-
dBc/Hz
SSB Phase Noise at 100Hz offset
-
-95
-
dBc/Hz
SSB Phase Noise at 1KHz offset
-
-130
-
dBc/Hz
SSB Phase Noise at 10KHz offset
-
-135
-
dBc/Hz
SSB Phase Noise at 100KHz offset
-
-140
-
dBc/Hz
INPUT CHARACTERISTICS
TABLE 3.0
PARAMETER
MINIMUM
NOMINAL MAXIMUM
UNITS
NOTE
Control Voltage Range
(Vc)
0.3
1.65
3.0
Vdc
Frequency Pullabilty
100
-
-
ppm
2
Absolute Pull Range
50
-
-
ppm
3
Monotonic Linearity
-10
-
10
%
Input Impedance
-
50K
-
Ohm
Modulation Bandwidth (3dB)
15
-
-
KHz
HCMOS OUTPUT CHARACTERISTICS
TABLE 4.0
PARAMETER
MINIMUM
NOMINAL MAXIMUM
UNITS
NOTE
LOAD
-
-
15
pF
Voltage (High)
(Voh)
2.4
-
-
Vdc
(Low)
(Vol)
-
-
0.4
Vdc
Current (High)
(Ioh)
-8
-
-
mA
(Low)
(Ioh)
-
-
8
mA
Duty Cycle measured at 1.5 Vdc
40
50
60
%
Rise / Fall Time 10% to 90%
-
-
5
nS
PACKAGE CHARACTERISTICS
TABLE 5.0
Package
Non-hermetic package consisting of an FR4 subst rate with grounded metal
cover.
PROCESS RECOMMENDATIONS
TABLE 6.0
Solder Reflow
The component solder used internal to this device has a m elting point of
221
C. The peak temperature inside the device should be less than or
equal to 220
C for a maximum of 10 seconds
Wash
Ultrasonic cleaning is not recommended.
THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
FAX (630) 851-5040.
PHONE (630) 851-4722.
HTTP://WWW.CONWIN.COM
P R O D U C T D A T A S H E E T
Specifications subject to change without notice.
DATA SHEET #:
REV:
DATE:
PAGE
OF
Copyright 2001 Connor-Winfield all rights reserved.
a
CRYSTAL CONTROLLED OSCILLATORS
2
2
Vx521
00
9/14/04
C
W
V
S
L
D
5
2
C
1
1
2
5
.
0
0
M
Dimensional Tolerance:
.005" (.127mm)
N/C
N/C
5
Pad
Connection
1
Control Voltage
2
N/C
3
Ground
4
Output
5
N/C
6
Vcc
PDF 
ZIP