ChipFind - документация

Электронный компонент: ITI-2135

Скачать:  PDF   ZIP
ITI-2135 and ITI-2147
PCI Bridged Riser Cards
Installation Guide
Part Number: 90-100260 A01
March 2000
2
ITI-2135 and ITI-2147
PCI Bridged Riser Cards
Installation Guide
Part Number: 90-100260 A01
March 2000
Revision/Update Information:
A01 - Initial Release
3
3
Contents
Introduction
4
Organization of this Guide
4
Overview of the Riser Cards
4
Power and Dimensional Specifications
5
Block Diagram
5
Riser Card Layout Diagram
8
Installing the ITI-2135 and ITI-2147
9
PCI Bridged Riser Cards
9
System Requirements
9
Installing the Riser Cards
9
List of Tables
11
List of Figures
11
Appendix A Connector Specifications
12
PRODUCT WARRANTY
14
LIMITED HARDWARE WARRANTY
14
LIMITATIONS
15
4
4
Introduction
This guide describes how to mount and install the ITI-2135 and ITI-2147 PCI
Bridged Riser Cards in your system.
Organization of this Guide
This guide is organized in the following way:
Overview of the Bridged Riser Cards
Power and Dimensional Specifications
Installing the Riser Card
Overview of the Riser Cards
The ITI-2135 and ITI-2147 Bridged Riser Cards provide a method of turning a
PCI slot 90
o
to enable a low profile 2U system to use standard height PCI cards.
The Riser provides three full function PCI slots. IntraServer Bridged Riser
Cards provide a PCI to PCI bridge chip that isolates the three additional slots
from the host PCI bus. Non-bridged riser cards can present unacceptable PCI
bus loading due to long stubs.
The IntraServer Riser Cards will operate in any PCI slot, 32 or 64 bit, 33 MHz
or 66 MHz, 3.3V or 5V signaling. The ITI-2135 and ITI-2147 are functionally
identical, but dimensionally the ITI-2147 is 0.3" shorter than the ITI-2135. See
Table 5 for the dimensional specifications of each card.
Part Number
Description
ITI-2135-3V
Bridged PCI Riser, 66 MHz, 3.3V PWRIO, 3 slots
ITI-2135-5V
Bridged PCI Riser, 33 MHz, 5V PWRIO, 3 slots
ITI-2147-3V
Bridged PCI Riser, 66 MHz, 3.3V PWRIO, 3 slots
ITI-2147-5V
Bridged PCI Riser, 33 MHz, 5V PWRIO, 3 slots
Table 1: Riser Cards included in this manual
Power and Dimensional Specifications
In order to operate the ITI-2135 or ITI-2147 Riser Card in your system, you
must have an available PCI slot for the card.
Block Diagram
Note: A Power Plane connects fingers and slots for 5V, 3.3V, -12V,
12V and 3.3VAUX
64 Bit PCI Connector /
Slot 2
64 Bit PCI Connector /
Slot 1
64 Bit PCI Connector /
Slot 0
64 Bit PCI-PCI
21154-* Bridge
Secondary PCI Bus
Primary PCI Bus
PCI Fingers
64 Bit