Integrated Circuits Group
LH28F640BFHE-PTTL80
Flash Memory
64M (4M 16)
(Model No.:
LHF64FA2)
Spec No.:
FM025005
Issue Date:
May 10, 2002
P
RELIMINARY
P
RODUCT
S
PECIFICATIONS
LHF64FA2
Handle this document carefully for it contains material protected by international copyright law. Any reproduction,
full or in part, of this material is prohibited without the express written permission of the company.
When using the products covered herein, please observe the conditions written herein and the precautions outlined in
the following paragraphs. In no event shall the company be liable for any damages resulting from failure to strictly
adhere to these conditions and precautions.
(1) The products covered herein are designed and manufactured for the following application areas. When using the
products covered herein for the equipment listed in Paragraph (2), even for the following application areas, be sure
to observe the precautions given in Paragraph (2). Never use the products for the equipment listed in Paragraph
(3).
Office electronics
Instrumentation and measuring equipment
Machine tools
Audiovisual equipment
Home appliance
Communication equipment other than for trunk lines
(2) Those contemplating using the products covered herein for the following equipment which demands high
reliability, should first contact a sales representative of the company and then accept responsibility for
incorporating into the design fail-safe operation, redundancy, and other appropriate measures for ensuring
reliability and safety of the equipment and the overall system.
Control and safety devices for airplanes, trains, automobiles, and other transportation equipment
Mainframe computers
Traffic control systems
Gas leak detectors and automatic cutoff devices
Rescue and security equipment
Other safety devices and safety equipment, etc.
(3) Do not use the products covered herein for the following equipment which demands extremely high performance
in terms of functionality, reliability, or accuracy.
Aerospace equipment
Communications equipment for trunk lines
Control equipment for the nuclear power industry
Medical equipment related to life support, etc.
(4) Please direct all queries and comments regarding the interpretation of the above three Paragraphs to a sales
representative of the company.
Please direct all queries regarding the products covered herein to a sales representative of the company.
Rev. 2.42
sharp
LHF64FA2 1
PAGE
48-Lead TSOP Pinout................................................. 3
Pin Descriptions.......................................................... 4
Simultaneous Operation Modes
Allowed with Four Planes .................................. 5
Memory Map .............................................................. 6
Identifier Codes and OTP Address
for Read Operation ............................................. 7
Identifier Codes and OTP Address for
Read Operation on Partition Configuration........ 7
OTP Block Address Map for OTP Program............... 8
Bus Operation ............................................................. 9
Command Definitions .............................................. 10
Functions of Block Lock and Block Lock-Down..... 12
Block Locking State Transitions upon
Command Write................................................ 12
Block Locking State Transitions upon
WP# Transition................................................. 13
Status Register Definition......................................... 14
PAGE
Extended Status Register Definition ......................... 15
Partition Configuration Register Definition.............. 16
Partition Configuration ............................................. 16
1 Electrical Specifications......................................... 17
1.1 Absolute Maximum Ratings ........................... 17
1.2 Operating Conditions ...................................... 17
1.2.1 Capacitance .............................................. 18
1.2.2 AC Input/Output Test Conditions ............ 18
1.2.3 DC Characteristics ................................... 19
1.2.4 AC Characteristics
- Read-Only Operations......................... 21
1.2.5 AC Characteristics
- Write Operations ................................. 24
1.2.6 Reset Operations ...................................... 26
1.2.7 Block Erase, Full Chip Erase,
(Page Buffer) Program and
OTP Program Performance.................... 27
2 Related Document Information.............................. 28
CONTENTS
Rev. 2.42
sharp
LHF64FA2 2
LH28F640BFHE-PTTL80
64Mbit (4Mbit
16)
Page Mode Dual Work Flash MEMORY
64M density with 16Bit I/O Interface
High Performance Reads
80/35ns 8-Word Page Mode
Configurative 4-Plane Dual Work
Flexible Partitioning
Read operations during Block Erase or (Page Buffer)
Program
Status Register for Each Partition
Low Power Operation
2.7V Read and Write Operations
V
CCQ
for Input/Output Power Supply Isolation
Automatic Power Savings Mode Reduces I
CCR
in Static Mode
Enhanced Code + Data Storage
5
s Typical Erase/Program Suspends
OTP (One Time Program) Block
4-Word Factory-Programmed Area
4-Word User-Programmable Area
High Performance Program with Page Buffer
16-Word Page Buffer
5
s/Word (Typ.) at 12V V
PP
Operating Temperature -40
C to +85C
CMOS Process (P-type silicon substrate)
Flexible Blocking Architecture
Eight 4K-word Parameter Blocks
One-hundred and twenty-seven 32K-word Main
Blocks
Top Parameter Location
Enhanced Data Protection Features
Individual Block Lock and Block Lock-Down with
Zero-Latency
All blocks are locked at power-up or device reset.
Absolute Protection with V
PP
V
PPLK
Block Erase, Full Chip Erase, (Page Buffer) Word
Program Lockout during Power Transitions
Automated Erase/Program Algorithms
3.0V Low-Power
11s/Word (Typ.)
Programming
12V No Glue Logic 9
s/Word (Typ.)
Production Programming and 0.5s Erase (Typ.)
Cross-Compatible Command Support
Basic Command Set
Common Flash Interface (CFI)
Extended Cycling Capability
Minimum 100,000 Block Erase Cycles
48-Lead TSOP
ETOX
TM*
Flash Technology
Not designed or rated as radiation hardened
The product, which is 4-Plane Page Mode Dual Work (Simultaneous Read while Erase/Program) Flash memory, is a low
power, high density, low cost, nonvolatile read/write storage solution for a wide range of applications. The product can
operate at V
CC
=2.7V-3.6V and V
PP
=1.65V-3.6V or 11.7V-12.3V. Its low voltage operation capability greatly extends
battery life for portable applications.
The product provides high performance asynchronous page mode. It allows code execution directly from Flash, thus
eliminating time consuming wait states. Furthermore, its newly configurative partitioning architecture allows flexible dual
work operation.
The memory array block architecture utilizes Enhanced Data Protection features, and provides separate Parameter and Main
Blocks that provide maximum flexibility for safe nonvolatile code and data storage.
Fast program capability is provided through the use of high speed Page Buffer Program.
Special OTP (One Time Program) block provides an area to store permanent code such as a unique number.
* ETOX is a trademark of Intel Corporation.
Rev. 2.42
sharp
LHF64FA2 3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
48
47
46
45
44
43
42
41
40
39
38
37
36
35
34
33
32
31
30
29
28
27
26
25
48-LEAD TSOP
STANDARD PINOUT
12mm x 20mm
TOP VIEW
A
15
A
14
A
13
A
12
A
11
A
10
A
9
A
8
A
21
A
20
WE#
RST#
V
PP
WP#
A
19
A
18
A
17
A
7
A
6
A
5
A
4
A
3
A
2
A
1
A
16
V
CCQ
GND
DQ
15
DQ
7
DQ
14
DQ
6
DQ
13
DQ
5
DQ
12
DQ
4
V
CC
DQ
11
DQ
3
DQ
10
DQ
2
DQ
9
DQ
1
DQ
8
DQ
0
OE#
GND
CE#
A
0
Figure 1. 48-Lead TSOP (Normal Bend) Pinout
Rev. 2.42
sharp
PDF 
ZIP