ChipFind - документация

Электронный компонент: L7207

Скачать:  PDF   ZIP

Document Outline

Data Brief
For further information contact your local STMicroelectronics sales office.
April 2006
Rev 1
1/3
3
L7207
Dual mode disk drive spindle and VCM motor driver
General features
Dual operative mode (Desktop and Mobile)
Register based architecture
Serial communication interface up to 40 MHz
Spindle driver
3A peak current drive capability
Internal power devices with 0.5
max bridge
impedance at 125C.
ST SmoothDrive architecture
Inductance sense start-up capability
Current sensing via integrated sense FET
VCM driver
2.4A peak current drive capability
Internal power devices with 0.5
max bridge
impedance at 125C
Linear and PSM VCM driving
Dual 14-bit linear DACs for current command
Power on/off ramp load and unload capability
Voltage retract mode
Other functions
2 linear regulators.
Programmable switching regulator
Negative switching regulator
Internal isolation FET
Voltage monitoring
Power On Reset with integrated delay
Shock sensor circuitry
8-bit ADC with multiplexed inputs
Thermal sense circuit and over temperature
shutdown
Description
L7207 is a motor controller IC designed for both
desktop and dobile hard disk drive applications.
The spindle motor driver subsystem integrates all
power FETs driven by ST's SmoothDrive
commutation technology. The voice coil driver
block includes the power FETs, as well as ramp
load and unload capability.
Linear voltage and switching regulators are
included, as well as a negative regulator and
power monitoring function.
L7207 embeds a serial interface with a maximum
speed of 40 MHz.
TQFP64
www.st.com
Revision history
L7207
2/3
1 Revision
history
Table 1.
Document revision history
Date
Revision
Changes
20-Apr-2006
1
Initial release.
L7207
3/3
Please Read Carefully:
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries ("ST") reserve the
right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any
time, without notice.
All ST products are sold pursuant to ST's terms and conditions of sale.
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no
liability whatsoever relating to the choice, selection or use of the ST products and services described herein.
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this
document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products
or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such
third party products or services or any intellectual property contained therein.
UNLESS OTHERWISE SET FORTH IN ST'S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED
WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS
OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.
UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZE REPRESENTATIVE OF ST, ST PRODUCTS ARE NOT DESIGNED,
AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING APPLICATIONS,
NOR IN PRODUCTS OR SYSTEMS, WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY, DEATH, OR
SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE.
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void
any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any
liability of ST.
ST and the ST logo are trademarks or registered trademarks of ST in various countries.
Information in this document supersedes and replaces all information previously supplied.
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.
2006 STMicroelectronics - All rights reserved
STMicroelectronics group of companies
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -
Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America
www.st.com